Mitsubishi Electric City Multi PKFY Series Technical & Service Manual page 29

OPERATION PROCEDURE
8. REMOVING THE VANE MOTOR
(1) Remove the front panel. (Refer to procedure 2)
(2) Remove the screw of the electrical parts box cover, and
remove the cover.
(3) Remove the 2 screws of the vane motor.
Disconnect the relay connector and remove the motor
from the shaft.
(4) Disconnect the vane motor connector (CN5V) on the
indoor controller board.
9. REMOVING THE LIQUID PIPE THERMISTOR AND GAS
PIPE THERMISTOR
(1) Remove the front panel. (Refer to procedure 2)
(2) Remove the electrical box cover. (See the Photo 2)
(3) Remove the water cut. (See the Photo 3)
(4) Cut the wiring fixed band.
(5) Remove the liquid pipe thermistor and gas pipe thermistor.
(See the Photo 10)
(6) Disconnect the connector (CN29) (CN21) on the indoor
controller board.
OCH461B
PHOTOS & ILLUSTRATIONS
Photo 10
Heat exchanger
Vane motor
Photo 11
Liquid pipe
thermistor
Gas pipe
thermistor
29
Vane motor fixing
screws
Nozzle assembly
Heat exchanger
Electrical box