Operation
Using Step Smart
NOTE: Step Smart is a warning device and is intended to assist with set up and
early notification that your ladder has moved with the aid of visual and audible
warnings. Step Smart does not replace general ladder safety
1. Once Step Smart is in Active Mode it will check for any change in the
stability of the ladder. Refer to page 14 to reference the Display Functions
2. Slow Red Flashing Lights with Slow Caution Beeping or Rapid Flashing
Lights with Rapid Beeping indicate minor changes in the stability of
the ladder. This occurs when the ladder and therefore the device, have
moved. This alarm will notify the user of a small change to the level
of your ladder, in this case review your surroundings for any changes,
by leaning safely you may be able to correct the level of your ladder,
if the alarm continues to sound the user should dismount the ladder
immediately to re-set the ladder to level
3. Two Solid Red Lights and a Constant Alarm Sound indicate significant
change to the stability of the ladder. This alarm will notify the user of a
substantial change to the level of your ladder, in this instance, the user
should dismount the ladder immediately. It is recommended that you
review your surroundings for any changes should the alarm continue
4. To power OFF your Step Smart device, press
and hold the ON/OFF button for 3 seconds
then release, you will hear 3 fast beeps and
the device will power off
NOTE:
• The device will automatically turn off:
- If left in Set Up Mode for more than 10 minutes
- If left in Active Mode for 8 hours without any change to the angle
• The device may alarm as you climb or dismount the ladder
- Depending on the weight of your step and the strength of your ladder
the device may alarm on each step, if this happens climb or dismount the
ladder slowly to ensure the alarm is due to heavy stepping rather than
movement of the ladder.
After Sales Support
1300 663 907
customercare@winplus.com.au
Model Number DY160121
13
Need help?
Do you have a question about the Step Smart and is the answer not in the manual?
Questions and answers