Advertisement
Here is the procedure for Cloning one radio's data to another:
1.
Turn both radios off.
2.
Connect the optional CT-27 Clone Cable between the MIC/SP jacks of the two radios.
3.
Press and hold in the MONI switch (just below the PTT switch) while turning the radios
on. Do this for both radios (the order of switch-on does not matter).
4.
Rotate the DIAL job on each radio to select to "F6 CLONE," then press the [F/W] key
momentarily.
5.
The display will disappear for a moment, then the "CLONE" notation will appear on the
displays of both radios when the Clone mode is successfully activated in this step.
6.
On the Destination radio, press the MONI switch ("--RX--" will appear on the LCD).
7.
Press and hold in the PTT switch on the Source radio; "--TX--" will appear on the Source
radio, and the data from this radio will be transferred to the other radio.
8.
If there is a problem during the cloning process, "ERROR" will be displayed. Check your
cable connections and battery voltage, and try again.
9.
If the data transfer is successful, "CLONE" will reappear on both displays. Turn both
radios off and disconnect the cloning cable. You can then turn the radios back on, and
begin normal operation.
The VX-120/170 Set Mode, already described in parts of many previous chapters, is easy to
activate and set. It may be used for configuration of a wide variety of transceiver parameters,
some of which have not been detailed previously. Use the following procedure to activate the
Set Mode:
1.
Press the [F/W] key, then press the [0(SET)] key to enter the Set mode.
2.
Rotate the DIAL knob to select the Set Mode Item to be adjusted.
3.
Press the [F/W] key momentarily to enable adjustment of the Set Mode Item.
4.
Rotate the DIAL knob to adjust or select the parameter to be changed on the Set Mode
Item selected in above step.
5.
After completing your selection and adjustment, press the PTT switch momentarily to
save the new setting and exit to normal operation.
R.F. Says: 1) Some Set Mode Items (like Set Mode Item 46: TN FRQ) require that the [F/W]
key be pressed after setting of the parameter, and before exiting to normal operation.
2) Two Set Mode Item numbers (in the factory default, Set Mode Item
SKIP) will blink while selecting the Set Mode Item; this indicates that this Set Mode Item has
been assigned to the [7(P1)] or [8(P2)] key of the keypad.
Set (Menu) Mode
53/64
FCC ID: K6620223X20
IC ID: 511B-20223X20
VX-120/170 O
PERATING
34: RF
SQL, and 42:
Vertex Standard Co., Ltd.
M
ANUAL
Advertisement
