Sauer Danfoss JS1000 User Manual page 7

JS1000_CAN Function Block Outputs
Output Type
Grp_Flt BOOL
GrpRaw_Flt BOOL
_Det_Flt BOOL
_Flt BOOL
YGrp_Det_Flt BOOL
YGrp_Flt BOOL
Y_Det_Flt BOOL
Y_Flt BOOL
Out ——
Btn1–Btn12 BOOL
R_BJM BOOL
PLUS+1 Compliant JS1000 Joystick with CAN Function Block
User Manual
JS1000_CAN Function Block
Range Description
—— Indicates if the input from a grip-mounted, y-axis proportional switch has a fault.
T = Fault.
F = No fault.
—— Indicates if the input from a grip-mounted, y-axis proportional switch with raw mode
has a fault.
T = Fault.
F = No fault.
—— Indicates if the input from a detent switch on the joystick's x axis has a fault.
T = Fault.
F = No fault.
—— Indicates if the input from the joystick's x axis has a fault.
T = Fault.
F = No fault.
—— Indicates if the input from a detent switch on the joystick's y axis has a fault.
T = Fault.
F = No fault.
—— Indicates if the input from a grip-mounted, y-axis proportional switch has a fault.
T = Fault.
F = No fault.
—— Indicates if the input from a detent switch on the joystick's y axis has a fault.
T = Fault.
F = No fault.
—— Indicates if the input from the joystick's y axis has a fault.
T = Fault.
F = No fault.
—— Outputs a bus that contains the following command signals. These signals indicate the
position of each joystick axis and the state of push-button and detent switches.
—— Indicates the states of grip-mounted push-button switches.
T = Closed.
F = Open.
—— Indicates when the function block receives a CAN Rx_BJM (Receive Basic Joystick
Message).
This message reports joystick x-axis and y-axis positions as well as the state of grip-
mounted button switches.
T = Message received.
F = Message not received.
11007135 Rev AC May 2010
7