Sony PMW-EX3 Operating Instructions Manual page 120

CAMERA SET
Menu items
3)
TLCS
Setting the Total
Level Control
System (auto
adjustment system
of gain, iris and
shutter)
Shockless
White
Setting the
shockless white
balance
White Switch
Setting for the
WHITE BAL
switch
ATW Speed
Setting for Auto
Tracing White
Balance
Wide
1)
Conversion
Setting for use of a
wide conversion
lens
1)
Valid with exclusive lenses only
120 Setup Menu List
Subitems and setting values Contents
Level
+1.0 / +0.5 / ±0 / –0.5 / –1.0
Mode
Backlight / Standard /
Spotlight
Speed
–99 to +99 (+50)
AGC
On / Off
AGC Limit
3 / 6 / 9 / 12 / 18 dB
AGC Point
F5.6 / F4 / F2.8
Auto Shutter
On / Off
A.SHT Limit
1/100
1/150
1/200
1/250
A.SHT Point
F5.6 / F8 / F11 / F16
Off / 1 / 2 / 3
ATW / MEM
1 / 2 / 3 / 4 / 5
On / Off
Set the target level (to make brighter or darker) of auto iris
control in TLCS. (This setting also affects the gain control in
AGC mode and shutter-speed control in Auto Shutter mode.)
+1.0: Approx. one stop further open
+0.5: Approx. half a stop further open
±0: Standard
–0.5: Approx. half a stop further closed
–1.0: Approx. one stop further closed
Set the auto iris control mode in TLCS.
Backlight: Backlight mode to reduce darkening of the center
subject against lights
Standard: Standard mode
Spotlight: Spotlight mode to reduce blown-out highlights on
the center subject in the spotlight
Set the tracing speed of TLCS control.
Turn the AGC (Auto Gain Control) function on/off.
Set the maximum gain in AGC.
Set the iris point for switching to auto-iris and auto-shutter
control when AGC is on.
Turn the Auto Shutter control function on/off.
Set the maximum shutter speed in Auto Shutter control.
Set the iris point for switching auto-iris and auto-shutter
control when Auto Shutter is on.
Select the speed of change in white balance when the white
balance mode is switched.
Set to "Off" to instantly change the white balance.
Select a larger number to change the white balance more
slowly through interpolation.
Select the mode (ATW or Memory B) selected at the B
position of the WHITE BAL switch.
Set the tracing speed of ATW.
The larger the number you set, the speed becomes faster.
Set to "On" when a wide conversion lens is attached.