Sony PMW-EX3 Operating Instructions Manual page 118

CAMERA SET
Menu items
Shot
1)
Transition
Setting the
operating
conditions of Shot
Transition
1)
MF Assist
Turning the MF
Assist Function
on/off
Color Bar Type
Selecting the types
of color bar
Flicker Reduce
Setting Flicker
Compensation
Zoom Speed
Setting the zoom
speed
118 Setup Menu List
Subitems and setting values Contents
Trans Time
2 to 15 sec (4 sec)
Trans Speed
1 to 10 (5)
Time / Speed
Time / Speed
Trans Curve
Linear / Soft Trans / Soft Stop
Start Timer
Off / 5 sec / 10 sec / 20 sec
Rec Link
Off / Shot-A / Shot-B
On / Off
Multi / 75% / 100%
Mode
Auto / On / Off
Off: UC model
Auto: Other models
Frequency
50 Hz / 60 Hz
60 Hz: UC model
50 Hz: Other models
Note:If you set a value between 0 and 9, zooming may not operate smoothly, depending on the
individual characteristics of the lens or operating environments.
High
0 to 99 (70)
Low
0 to 99 (30)
Remote
0 to 99 (50)
Set the time it takes to make a shot transition.
Set the speed of the transition.
Determine whether to specify the transition by time or speed.
Select the transition pattern.
Linear: To make the transition linearly
Soft Trans: To make the transition slowly at the beginning and
end, but linearly in between
Soft Stop: To make the transition slow down near the end
Set the waiting time until the shot transition begins.
Set the function to start a shot transition linked to recording
start.
Off: To start the transition using a button without linked to
recording start
Shot-A: To start a transition to Shot-A linked to recording
start
Shot-B: To start a transition to Shot-B linked to recording
start
Set to "On" to precisely adjust the focus automatically after
you roughly adjust it manually.
Select the type of color bars displayed when you press the
BARS/CAM button.
Multi: To output multiformat color bars
75%: To output 75% color bars
100%: To output 100% color bars
Set the operation of the Flicker-Reduction function.
On: To always activate it
Auto: To automatically activate it when flicker is detected.
Off: To not activate it
Set to the power supply frequency of the light source causing
flicker.
Set the speed of zooming to be executed when you press the
on-handle ZOOM button with the zoom speed switch set to
H.
Set the speed of zooming to be executed when you press the
on-handle ZOOM button with the zoom speed switch set to L.
Set the speed of zooming to be executed when you press the
ZOOM button of the IR Remote Commander.