Master/Slave Mode - leahua 1440RGB User Manual

Master/Slave Mode

The Master/Slave mode allows a single 200W LED Spot (the master) to control the
actions of one or more 200W LED spot products (the slaves) without the need of a DMX
controller. The master will be set to operate in either Automatic or Sound-Active mode,
while the slaves will be set to operate in Slave mode. Once set and connected, the
slaves will operate in unison with the master.
Configure the products as indicated below.
Slaves:
1. Press <MENU>.
2. Use <UP> or <DOWN> to choose Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Slave.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select Slave1, Slave2, Slave3, or Slave4.
· Select Slave1 for 100% synchronized actions.
· Select Slave2, Slave3, or Slave4 for a delayed show with all heads in the
same direction but with a delay creating a wave effect.
7. Press <ENTER>.
8. Connect the DMX input of the first slave product to the DMX output of the master.
9. Connect the DMX input of the subsequent slaves to the DMX output of the
previous slave.
10. Finish setting and connecting all the slaves.
Master:
1. Set the master to operate in either Automatic or Sound-Active mode.
2. Make the master the first product in the DMX daisy chain.
www.leahualight.com 20