Advertisement
44
Wi l s o n Au d i o S u b s o n i c I n s t a l l a t i o n G u i d e
to check left to right oriented axis. If it is level, move to the
next step.
9.
If the bubble shows that the speaker is leaning toward the
center of the room, you will have to lengthen one of the inside
spikes down toward the floor. If the bubble is leaning toward
the outside of the room, you will have to lengthen one of the
outside spikes down toward the floor.
10. You may rotate the spike tips in place by using a vice -grip or
toothed pliers.
11. To find out which spike to lower, grasp the Wilson Audio Sub-
sonic channel and rock it back and for th. This will identify the
spike that is out of level from the other three.
Place a level on the front to back oriented axis. If it is level, then your
Wilson Audio Subsonic's are level. Using the same process as above, adjust the
front or rear spikes to achieve front to back level.
Section 4.4—Removing the Protective Film
To protect the finish of the Wilson Audio Subsonic during final manufac-
ture, shipment, and setup in your listening room, we have applied a removable
layer of protective film over the finish. We recommend that this film be left in
place until the speakers are in their final location in your listening room. Once
A u t h e n t i c
E x c e l l e n c e
Advertisement
