Advertisement
s
Section 2.2—Connecting the Controller
Connect the Controller to the Wilson Audio Subsonic Amplifier
The "LOW PASS OUT " connectors labeled "1" and "2" are the output signal connectors for the
subwoofer amplifier. The Controller sums the left and right channels so both "1" and "2" outputs
contain identical signals. There is a single –ended and a balanced connector for each output. If
you are using one subwoofer, connect the amplifier driving the subwoofer to the Controller 's
"LOW PASS OUT " via the "1" output. Choose either the balanced cable or single –ended output to
match the input configuration of the amplifier.
If you are using two subwoofers with separate amplifiers, connect the second amplifier
channel to the "2" output. By using "Y" connectors (contact your Wilson dealer for details), you
can connect the controller to more than two subwoofer amplifiers.
W i l s o n
A u d i o
2 � 2 — C
e C t I o n
o n n e C t I n G t h e
S p e c i a l t i e s
13
C
o n t r o l l e r
Advertisement
