3-3. DIAGNOSTIC Mode
The DIAGNOSTIC mode is used for checking the VTR.
n
Use this mode with the tape stopped.
Buttons description
1. DIAGNOSTIC button
1. DIAGNOSTIC button
Press to enter and exit the DIAGNOSTIC mode.
2. ADVANCE button
Shifts the left digit of menu one step.
3. SHIFT button
Shifts the right digit of menu one step.
OPERATION
1. Press the DIAGNOSTIC button on the side panel with a stick tip, etc. to enter the DIAGNOSTIC
mode.
2. To shift the menu, press the ADVANCE or SHIFT button.
ADVANCE button : Shifts the left digit one step at a time.
SHIFT button :
Shifts the right digit one step at a time.
3. To exit the DIAGNOSTIC mode, press the DIAGNOSTIC button again.
HDW-F900 P1E2
3. SHIFT button
2. ADVANCE button
ADVANCE
SHIFT
PRESET
F-RUN
SET
R-RUN
REGEN
DIAG
REAL
TIME
DF
ON
OFF
NDF
SET
Time code/audio control panel
CH-1
CH-2
LEVEL
0
10
0
10
AUTO
MANUAL
AUDIO SELECT
AUDIO IN
FRONT
REAR
CUE IN
MIX
CH-1
CH-2
3-3. DIAGNOSTIC Mode
3-3