Table of Contents
Advertisement
2-5. Plug-in Board Removal and
Installation
2-5-1. General Information of Plug-in Board
Removal and Installation
Removal with the Tool
Board removing tool (Sony Part No. : J-6309-350-A)
1. Insert the board removing tool in the hole on the panel
at the top of the board, move the tool in the direction
of the arrow, and disconnect the connector connected
to the mother board.
Panel hole
2. Remove the board from the unit by holding the pull
ring in front of the board.
HDW-F900 P1E2
Board removing tool
. Installation
Groove of guide rail
Plug-in board
Pull ring
2-5. Plug-in Board Removal and Installation
Removal Without the Tool
1. Insert a screwdriver having a small tip into the panel
hole on the top of the board, move the tool in the
direction of the arrow, and disconnect the connector
connected to the mother board.
2. Holding the pull ring in front of the board, remove the
board from the unit
Screwdriver, etc.
Panel hole
Installation
1. Insert the board according to the board guide rails at
the top and bottom of the unit.
2. Hold the top and bottom of the board firmly, and insert
the board connector into the mother board.
Pull ring
2-13
Advertisement
Table of Contents
