Johnson Controls DRCR Owner's Manual page 10

● Press this button to set up the swing angle, which sequentially changes as shown.
● When the guide louver starts to swing up and down, if SWING funtions
SWING
●
6
UP/DOWN
directions.(Simplified SWING function applicable for some fan coil units.
Button
When the wireless remote controller is energized initially with the unit
● By pressing this button, the clock is allowed to be set, with
and then press the +/- button to adjust the clock within 5 seconds. If
the +/- button is pressed down continuously for more than 2 seconds,
CLOCK
7
the clock setting will be increased or decreased by 10 minutes every
Button
0.5 seconds. After that, another press on the CLOCK button accepts
the setting. 12:00 is the default, when the wireless remote controller
is energized.
● When TIMER ON is activated, ON will blink while the symbol
TIMER ON
8
Button
● Pressing this button can activate or deactivate the X-FAN function.
X-FAN
9
Button
is canceled, the air guide louver will stop and remains at the current
position.
indicates the guide louver swings up and down among those five
under the OFF status, it should be set by pressing the + button and the
SWING button simultaneously, with the symbol
after the unit is turned on, this function can be activated by pressing the
SWING button, with the displayed symbol
on and without this displayed symbol indicating swing function is off.)
disappear. Within 5 seconds, set the ON time by pressing the +/-
button. Each press will make the time increase or decrease by 1
minute. The time can also be set by pressing and holding the +/-
button. Within the first 2.5 seconds, the time will increase/
decrease quickly by minute, and in the next 2.5 seconds, the time
will increase/decrease by 10 minutes. After the desired time value
is set, press TIME ON again to conform the setting within 5 seconds.
After that, another press of TIMER ON will cancel the setting.
Prior to this setting, the clock should be set to the actual time.
In Cool or Dry mode, by pressing this button,if "
indicates the X-FAN function is activated. By repressing this button,
if " " disappears, it indicates the X-FAN function is deactivated.
Upon initial power up, the X-FAN function is defaulted to OFF. If the unit
is turned off, X-FAN can be deactivated but can't be activated.
Wireless Remote Controller DRCR
3
blinking twice. Then,
indicating swing function is
blinking,
" is displayed, it
will