Recording An Index Signal; Reviewing The Most Recently Recorded Scenes (Rec Review); Searching For The Last Scene Of The Most Recent Recording (End Search) - Sony Handycam HDR-FX7 Operating Instructions Manual

Assigning the functions to the ASSIGN buttons (Continued)

Recording an index signal

If you make an index for a scene, you can
easily search for the scene later (p. 50).
The index function will make it easier to
check the transition of recording or edit
your pictures using index signals.
1
Assign [INDEX MARK] to one of
the ASSIGN buttons in advance
(p. 42).
2
Press the ASSIGN button
assigned to [INDEX MARK].
When pressed during recording
appears for about 7 seconds and an
index signal is recorded.
When pressed during standby
flashes.
After you press the REC START/STOP
button to start recording,
for about 7 seconds and an index signal
is recorded.
To cancel the operation
Before starting to record, press the ASSIGN
button assigned to [INDEX MARK] again.
b Note
• You cannot record an index signal on a recorded
tape afterward.
44
Reviewing the most recently
recorded scenes (Rec review)
You can view about 2 seconds of the scene
recorded just before you stopped the tape.
This is convenient during playback of the
latest scene check.
1
2
Searching for the last scene of
appears
the most recent recording
(End search)
b Note
• End search will not work correctly when there is
a blank section between recorded sections on
the tape.
1
Assign [REC REVIEW] to one of
the ASSIGN buttons in advance.
(p. 42).
Press the ASSIGN button
assigned to [REC REVIEW] during
standby mode.
The last 2 seconds (approx.) of the most
recently recorded scene are played back.
Then, your camcorder is set to the
standby.
Assign [END SEARCH] to one of
the ASSIGN button in
advance(p. 42).