Advertisement
Getting to know your machine
Carry handle
Dirt container
release button
Pre-motor ilter
(hidden)
Dirt container lid
Dirt container
Separator
Filter release clip
Height adjuster dial
Floorhead
Technical Speciication
Name Power Nano
Voltage 220-240V
Wattage 850W
Weight 5.25kg
Subject to technical change without notice.
Handle
Dust brush holder
Handle release button
Upper release
cord hook
Extension tube
and crevice tool
Hose inlet
Hose
On/Of button
Hose connector
Accessories & Consumables
Filter Kit (Type 110)
Crevice Tool (Type 16)
1-1-134394-00
1-1-134427-00
Belt Kit (Type 25)
Dusting Brush (Type 10)
1-1-134411 -00
1-1-134426-00
TurboTool (Type 6*)
1-1-134419-00
* Selected models only.
To purchase consumables and accessories, please visit
vax.co.uk
PLEASE READ 'LET'S TALK SAFETY' AT THE BEGINNING BEFORE USE
Before you begin cleaning
CAUTION: Always switch of the vacuum cleaner before connecting or disconnecting the hose/attachments
or removing and emptying the dirt container.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner of. If this happens switch the vacuum cleaner of
and unplug from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages.
Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned the ilters please wait 24 hours for the
ilters to fully dry before putting back into the machine).
Filters require cleaning at least every 3-6 months. If the vacuum cleaner is blocked, switch of and unplug before
removing the blockage.
When the vacuum cleaner is stood in the upright position, or when using the hose and tools the brushbar height adjuster
must be set to the highest setting.
Assembling your vacuum cleaner
Lift handle up and click into place.
Line up latch on accessory hose,
push until clicks into place.
Push extension tube and crevice tool
Put dusting brush into dusting
onto holder.
brush holder with brushes
facing outwards.
Getting started
Push accessory hose into hose
to machine connector.
Line up TurboTool brushes into
TurboTool holder, push into place
until it clicks (some models only).
Advertisement
