Advertisement
Let's talk technical
Removing a blockage from the hose
Remove hose end from the
Lift clip under the
hose to machine connector.
hose inlet.
Line up latch on accessory hose and
push until clicks into place Push the other
end of the hose into machine connector.
Replacing the belt
Lie vacuum cleaner
Lift to remove
on its back exposing
brushbar cover.
brushbars. Use a cross
head screwdriver.
Undo 5 screws.
Place belt on rounded
Line up right side of
area of brushbar
brushbar with base, push
without bristles.
into place. Lift and push
left side of brushbar until
clicks into place.
Pull latch out and
Insert a broom handle or
remove hose.
similar blunt instrument into
the hose to remove blockage.
Test for blockages by dropping a small ball
of paper through the hose. Remove any
blockage by inserting wire.
Lift to remove
Clean any debris from
brushbar. Remove and
spindle. Place new
dispose of old belt.
belt on spindle.
If the brushbar does not
rotate easily then the belt
Line up brushbar
may not have been itted
cover, push until it
correctly. Make sure the
clicks into place.
belt is not twisted.
Replace 5 screws
CAUTION
and tighten.
Don't forget your accessories!
Order at:
www.vax.co.uk/spares-and-solutions
Pro Cleaning Kit (Type 2)
1-1-133326-00
All our best tools all in one kit that makes cleaning
your home quicker, easier and with even better results.
We've taken care of cleaning all of the hard to reach
areas such as on top of cupboards and in between
blinds to the dust that collates behind and
within the radiator.
TurboTool (Type 6)
1-1-134419-00
Use the TurboTool for vacuuming your stairs,
upholstery and car interiors. It's great for picking up
stubborn pet hair.
Accessories
Advertisement
