Advertisement
Taking care of your machine
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the machine should overheat,
the thermostat will automatically turn the machine of. Switch of and unplug the vacuum cleaner. Check the
machine for blockages and clean the ilters. Wash the pre-motor ilters with warm water (40°C max) and leave
for 24 hours or until fully dry before replacing into the machine.
Filters require cleaning at least every 3-6 months (depending on the level of use).
Don't use your vacuum cleaner without all the ilters in place.
Emptying the dirt container
Press the dirt container
Hold dirt container
release button, pull to remove.
over a bin.
Cleaning the HEPA media pre-motor ilter
Turn the dirt container
Turn the HEPA
lid anti-clockwise,
media pre-motor
lift to remove.
ilter anti-clockwise,
pull to remove.
24hr
Rinse under water
Leave to dry for
(max 40°C).
24 hours or until
fully dry before
placing back in the
vacuum cleaner.
Press the dirt release clip,
allowing dirt/debris to fall out.
Tap HEPA media
pre-motor ilter over
a bin to remove
any dirt/debris.
Don't over ill the
dirt container to
avoid blocking the
air low through
the vacuum cleaner
Line up HEPA media
and replace ilters
pre-motor ilter tabs
every 6-9 months.
in dirt container lid,
turn clockwise until it
clicks into place.
Taking care of your machine
Cleaning the separator
Turn separator
Tap separator over
anti-clockwise
a bin to remove
to 'unlock', pull
any dirt/debris.
to remove.
Post-motor ilter maintenance
IMPORTANT: The post motor ilter is designed to ofer long life with no maintenance. The ilter should be
checked periodically and when heavily discoloured it should be replaced. Please do not wash, scrub or brush the
ilter as this will damage it.
Press post-motor
Remove post-
ilter cover clip,
motor ilter.
pull to remove.
Storing your vacuum cleaner
Wrap the power cable
Press handle
around the quick cord
release button.
release hooks.
Using a soft brush
Line up tabs on
clean any dirt/debris
separator with dirt
out of the separator.
container, turn
separator clockwise
to 'lock' and click
into place.
Check the post
motor ilter for
any discolouration.
Always use the
Lower handle
carry handle to lift
downwards.
and carry the machine.
The separator
should sit on seal
in bottom of dirt
container when
correctly itted.
Advertisement
