Features; Assembly; Operation - Ryobi P4002 Operator's Manual

PRODUCT SPECIFICATIONS
Cable Diameter ........................................................ 0.25 in.
Cable Length ...............................................................25 ft.
Power Source ................. 18 Volt DC/120 V, AC only, 60 Hz
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack or unplug power cord from
your product when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing
battery pack or unplugging power cord will prevent
accidental starting that could cause serious personal
injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.

FEATURES

Minimum Pipe Size (diameter) ................................. 0.75 in.
Maximum Pipe Size (diameter) ..................................... 2 in.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

APPLICATIONS
You may use this product for the purposes listed below:
 Clearing obstructions from sinks and bathtubs.
NOTICE:
This product is designed to be powered by either a
RYOBI One+
™
power (AC mode). Either power source can be used by
installing an approved battery pack or power cord into
the product as described in this manual.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 13.
 Lock the switch trigger by placing the direction of rotation
selector in center lock position.
 Insert the battery pack into the battery port.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
8 — English
18V battery pack (DC mode) or by electric
™