Finishing - Heatilator CALIBER DESIGNER B-VENT SERIES Installation And Operating Instructions Manual

CALIBER DESIGNER SERIES
1. Combustible Finishing Material
Material made of or surfaced with wood, compressed
paper, plant fibers, plastics, or any material capable
of igniting and burning, whether flame proofed or not,
plastered or unplastered (this includes drywall).
2. Noncombustible Finishing Material
Material which will not ignite and burn. Such materials
are those consisting entirely of steel, iron, brick, tile,
concrete, slate, glass or plasters, or combination
thereof, or have a UL Fire rating of zero (0).
3. High Temperature Sealant Material
Sealants that will withstand high temperatures:
General Electric RTV103 (Black) or equivalent.
Rutland, Inc. Appliance Mortar #63 or equivalent.
A high temperature sealant, 1/8” inch wide minimum,
must be used to close off gaps between the appliance
and facing to prevent cold air leaks. See Figure 14.
4. Combustible Mantel
A combustible mantel may be installed at a minimum
of 42 inches above the base of the appliance and a
maximum depth of 12”.
WARNING!
01/04
G. FINISHING
5. Attach the Hood
The hood is to be located above the glass panel. The
hood must be attached or a fire hazard may result.
Locate the three tabs just inside the upper section of
the appliance. Position the hood and slide into
position. See Figure 15.
6. Remove the Glass and Screen
See page 20 of this manual.
7. Prepare the Appliance
The log set should look similar to that in Figure 16.
13