Heatilator CALIBER DESIGNER B-VENT SERIES Installation And Operating Instructions Manual page 12

reconstruction.
5. Junction Box Installation Instructions
Remove the junction box assembly from the valve compartment.
If the box is being wired from the OUTSIDE of the appliance:
Loosen two screws on the Romex connector, feed the necessary length of wire through the connector and
tighten the screws.
Make all necessary wire connections to the receptacle and assemble the receptacle and cover to the
junction box.
Attach the junction box assembly to the outside of the appliance with the two screws provided.
If the box is being wired from the INSIDE of the appliance;
Pull the electrical wires from outside the appliance through this opening into the valve compartment.
Loosen the two screws on the Romex connector, feed the necessary length of wire through the connector
and tighten the screws.
Make all necessary wire connections to the receptacle and assemble the receptacle and cover to the
junction box.
Attach the junction box assembly to the inside of the appliance with the two screws provided.
If the box is not to be wired at the time of appliance installation, assemble the receptacle and cover to the box
and install on the inside of the appliance.
12
A wiring diagram is shown in Figure 13.
Wiring for optional accessories should be done now to avoid
WARNING!
33795 Rev i
CALIBER DESIGNER SERIES
01/04