Heatilator CALIBER DESIGNER B-VENT SERIES Installation And Operating Instructions Manual page 11

CALIBER DESIGNER SERIES
3. Gas Conversions
Natural or propane gas fuel conversions necessary
to meet the application need to be made by a qualified
technician using Hearth & Home Technologies
specified and approved parts.
In the event your appliance must be converted to
propane/standing pilot, use
natural gas/standing pilot, use
propane/intermittent pilot, use
natural gas/intermittent pilot, use
WARNING!
01/04
4. Wiring
;
;
;
.
Note:
grounded in accordance with local codes or, in the
absence of local codes, with
11
This appliance requires a 110VAC supply to
the appliance junction box for operation. A
wiring diagram is shown in Figure 12.
This appliance is equipped with an
intermittent pilot control valve which operates
on a 3V system.
This appliance is supplied with a battery pack
and a 3VAC transformer, which requires the
installation of the supplied junction box. We
highly recommend that the junction box be
installed at this time to avoid reconstruction.
The battery pack requires two D cell batteries
(not included). Batteries cannot be placed in
the battery pack while using the 3VAC
transformer. Conversely, the transformer
must be unplugged if the battery pack is used.
This appliance must be electrically wired and
or the
.
CAUTION: