Application Directory; Ip Address On Delivery - Festo CMXR-C1 System Manual

3. Modular multi-axis control system CMXR
3.4

Application directory

All configuration data, FTL project data and program data are stored in the
"application\control" directory.
Illustration of the directory structure for the application directory:
The application directory includes a "control" directory. This is divided into the following
directories:
The "teachcontrol" directory contains all FTL projects which are each represented by a
directory. All FTL programs assigned to the project are located in this project directory.
In the above graphic, the projects "_global" and "cube" are created as examples.
3.5

IP address on delivery

The CMXR multi-axis control system has, on delivery, a minimal installation on the memory
card so that the network connection can be established after connection to the power supply.
The network settings are pre-assigned as follows:
To establish a connection to the CMXR multi-axis control system, the corresponding network
settings have to be undertaken on the PC.
Festo GDCP-CMXR-SY-EN 0805NH
Directory name Meaning
config Target directory of the application configuration
ieccontrol Not in use
teachcontrol Contains all FTL projects
text Contains any message texts in the application
Table 3.3 Application directory
Network parameter
IP address
Subnet mask
Gateway address
Table 3.4 Preset network parameters
Value
192.168.100.100
255.255.255.0
0.0.0.0
17