NuAire iSense Installation And Maintenance

NuAire iSense Installation And Maintenance

230v flush mounted domestic continuous extract fans

Advertisement

iSense & iSense-HT
230V Flush Mounted
Domestic Continuous Extract Fans
Installation and Maintenance
1.0 SAFETY INFORMATION
The installation must be completed by competent persons in accordance with good
industry practice and should conform to all governing and statutory bodies i.e. IEE,
CIBSE, HVCA, etc.
If the environment in which the product is installed also houses a fuel-operating
device (water heater, methane stove etc. that is not a "sealed chamber" type), it
is essential to ensure adequate air intake, to ensure good combustion and proper
equipment operation.
Ensure adequate air return into the room in compliance with existing regulations in
order to ensure proper device operation. Ensure the fans capability by checking the
performance fan curve. Flexible ducting is not recommended.
Disconnection from the supply mains must be incorporated within the fixed wiring in
accordance with the wiring regulations and shall have a minimum contact separation
of 3mm in accordance with the latest edition of the IEE Wiring Regulations.
In case of window installation it is necessary to use the appropriate window kit,
which is not included. Glass thickness from 11mm to 35mm.
This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved. Cleaning and user maintenance
should not be made by children without supervision. The unit is not intended for use
by persons (including children) with reduced physical, sensory or mental capacities
or those with a lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the unit from a person responsible for
their safety. Children should be supervised to ensure that they do not play with the
unit.
*for wall/window mounted installations only
IPX4*
10. 12. 18. Document Number 671886
The EMC Directive
2014/30/EU
The Low Voltage
Directive
2014/35/EU
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iSense and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for NuAire iSense

  • Page 1 & iSense-HT 230V Flush Mounted The EMC Directive Domestic Continuous Extract Fans 2014/30/EU The Low Voltage Directive Installation and Maintenance 2014/35/EU IPX4* 1.0 SAFETY INFORMATION • The installation must be completed by competent persons in accordance with good industry practice and should conform to all governing and statutory bodies i.e. IEE, CIBSE, HVCA, etc.
  • Page 2: Installation And Maintenance

    Please read these instructions carefully before installing the fan unit. Failure to comply with these instructions could reduce both the life and performance of the product and may invalidate the warranty. Nuaire assume no responsibility for damage to persons or property resulting from failure to observe the regulations contained in this booklet.
  • Page 3: Wall Installation

    Installation and Maintenance 4.0 IMPORTANT NOTES TO INSTALLERS Figure 2. Unscrewing front fixing screws. Before commencing any work read the following instructions carefully and ensure you have the necessary competency to complete the work safely. The installation must be completed by competent persons in accordance with good industry practice and should conform to all governing and statutory bodies i.e.
  • Page 4: Operation

    Installation and Maintenance iSense - 230V Extract Fan 6.0 WIRING IMPORTANT Disconnection from the supply mains must be incorporated within the fixed wiring in accordance with the wiring regulations and shall have Isolation: Before commencing work, make sure that the unit,...
  • Page 5: Warranty

    After Sales Department. 7.7 Decentralised Mechanical Extract Ventilation (dMEV) Telephone 02920 858 400 iSense units are suitable for decentralised mechanical extract aftersales@nuaire.co.uk ventilation and are recognised by the Government’s Standard Assessment Procedure (SAP) under the Product Characteristic Database (PCDB).

This manual is also suitable for:

Isense-ht

Table of Contents