Maintenance - Husqvarna 550iBTX Operator's Manual

5. Release the power trigger and push the Cruise
control button to stop the Cruise control function.
To increase the airflow to maximum
1. Start the product. Refer to
page 15 .
2. Push the Boost mode button to enable maximum
airflow when the power trigger is pushed. The LED
comes on to show that the Boost mode function is
on. The Boost mode function has no time limit.
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.
Maintenance schedule

Maintenance

Clean the external surfaces of the product with a clean and dry cloth. Do not use
water.
Keep the handles dry and clean. Remove oil or grease.
Make sure that the start/stop button operates correctly and is not damaged.
Make sure that the power trigger operates correctly.
Make sure that nuts and screws are tight.
Make sure that the release buttons on the battery works and locks the battery
into the product.
Make sure that all couplings, connections and cables are not damaged and re-
move dirt.
Make sure that the connections between the battery and the product are not
damaged.
16
To start the product on
Maintenance
3. Push the Boost mode button again to stop the Boost
mode function.
Daily Weekly Monthly
X
X
X
X
X
X
X
790 - 001 - 05.12.2018
X