Assembly - Husqvarna 550iBTX Operator's Manual

• Replace worn or damaged
parts.
• If you do not do maintenance,
it decreases the life cycle of
the product and increases the
risk of accidents.
• Special training is necessary
for all servicing and repair
work, especially for the safety
devices on the product. If not
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the tube and handle on
the product
1. Put the clamp (B) on the flexible tube (C) and attach
the flexible tube to the blower outlet (A).
B
A
2. Make sure to put the clamp screw (D) as the
illustration shows. Tighten the screw.
3. Attach the transport strap (O) to the guide track of
the joint swivel (H).
O
790 - 001 - 05.12.2018

Assembly

C
D
H
all checks in this operator's
manual are approved after
maintenance, speak to your
servicing dealer. We
guarantee that there are
professional repairs and
servicing available for your
product.
• Only use original spare parts.
4. Put the clamp (B) on the flexible tube (C) and attach
the joint swivel (H).
B
C
5. Make sure to put the clamp screw (D) as the
illustration shows. Tighten the screw.
6. Align the knobs (J) to each side of the joint swivel
(H).
7. Attach the control handle (I) to the guide track (K) of
the joint swivel (H). Make sure that the screw on the
control handle is on the bottom side of the control
pipe.
K
J
H
8. Tighten the screw on the control handle fully.
H
D
I
13