Operation - Husqvarna 550iBTX Operator's Manual

9. Connect the intermediate pipe (L) to the joint swivel
(H). Make sure that the knob (J) aligns with the guide
track of the intermediate pipe.
L
H
J
10. Turn the intermediate pipe fully to lock the control
pipe and the intermediate pipe.
11. Connect the blow pipe (M) to the intermediate pipe
(L). Make sure that the knob (N) on the intermediate
pipe points up and goes into the guide track of the
blow pipe.
12. Turn the blow pipe fully to lock the intermediate pipe
and the blow pipe.
13. Attach the sleeve around the flexible tube and the
cable as shown in the illustration. Close the zipper.
To adjust the harness
A correctly adjusted harness and product makes
operation easier. Adjust the harness to give the best
operation position.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
14
M
N
1. Put on the harness of the product.
B
C
2. Connect the hip strap with the clip (C). Tighten the
strap until the weight of the product is on your hips.
3. Tighten the side straps (B) until the product is tight
against your body.
4. Connect the chest strap to the clip (A).
5. Tighten the strap.
To put the product in transportation
mode
1. Turn the blower tube counterclockwise until it points
up.
2. Connect the transport clip.

Operation

To connect the battery to the
product
1. Make sure that the battery is fully charged.
2. Pull out the locking handles.
A
WARNING: Only use Husqvarna original
batteries in the product.
790 - 001 - 05.12.2018