Download Print this page

Operation - Husqvarna BA 3000 Instruction Manual

Advertisement

on a continual and regular basis must monitor
closely their physical condition and the condition
of this tool.
SAVE THESE INSTRUCTIONS
WARNING:
Always disconnect pow-
erhead spark plug before removing or instal-
ling attachments.
REMOVING BLOWER ATTACH-
MENT
CAUTION:
When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Upper Shaft
Coupler
LOOSEN
Lower
Attachment
TIGHTEN
2. Press and hold the locking/release button.
Locking/Release
Button
Coupler
Lower Attachment
3. While securely holding the upper shaft,
pull the attachment straight out of the
coupler.
INSTALLING ATTACHMENT
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Position locking/release button of attach-
ment into guide recess of upper shaft
coupler.
Coupler Primary Hole
Locking/
Upper
Release
Shaft
Button
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
Your attachment is fully assembled; no as-
sembly is necessary.

OPERATION

WARNING:
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit. All attachments are designed
to be used in the primary hole unless otherwise
stated in the applicable attachment instruction
manual. Using the wrong hole could lead to seri-
ous injury or damage to the unit.
Locking/Release
Button in Primary Hole
INSTALLING ATTACHMENT
Knob
HANGER
An attachment hanger is provided for storage
when attachment is not in use. To install hang-
er on attachment:
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Press and hold the locking/release but-
ton.
3. Push hanger onto the attachment until
the locking/release button snaps into the
Upper Shaft
hole.
OPERATING POSITION
ALWAYS WEAR:
Hearing
Protection
Guide Recess
WARNING:
using the unit. Remove all debris and hard
objects such as rocks, glass, wire, etc., that
Attachment
can ricochet, be thrown, or otherwise cause
injury or damage during operation.
Use your blower attachment for:
S Sweeping debris or grass clippings from
driveways, sidewalks, patios, etc.
S Blowing grass clippings, straw, or leaves into
piles, or removing debris from corners,
around joints, or between bricks.
-- 4 --
ASSEMBLY
Make sure the locking/
Secondary Hole
Eye Protection
Inspect the area before

Advertisement

loading