3. USING THE BABY MONITOR
Please read these instructions carefully, and be aware that
Baby Monitor is only intended as an aid.
It is not a substitute for responsible adult supervision.
3.1 Setting Up
•
Make sure that the Baby Unit is switched on.
•
Place the Baby Unit in a convenient location (e.g.
on a table, mount on wall...etc) and point the
camera lens towards the area you want to monitor.
NOTE:
•
Do not place the Baby Unit within reach of a child
or baby! If there is interference with the picture or
sound, try moving the units to different locations,
and ensure that they are not close to any other
electrical equipment.
•
If you hear a high pitched noise. This is certainly
not a defect.As the unit is designed to be operated
at some distance. So move the unit further apart to
avoid this noise.
•
It is recommended to only use a Class 10 micro-SD
up to 32GB. (Facing the camera, insert the micro-
SD card with the label towards you)
Page | 24
3.2 Power On or Off the Baby Unit
•
To turn on the Baby Unit, slide the ON/OFF switch
to the ON position to switch on the Baby Unit.
The power indicator lights up in blue.
•
To turn off the Baby Unit, slide the ON/OFF switch
to the OFF position to switch off the Baby Unit. The
power indicator goes off if the battery is not being
charged, or lights up in red if it is charging.
Using the Baby Monitor