Table of Contents
Advertisement
3. USING THE BABY MONITOR
Please read these instructions carefully, and be aware
that this Baby Monitor is only intended as an aid.
It is not a substitute for responsible adult supervision.
3.1 Setting Up
•
Make sure that the Baby Unit and Parent Unit are
both switched on.
•
Place the Baby Unit in a convenient location (e.g.
on a table, mount on wall...etc) and point the
camera lens towards the area you want to monitor.
NOTE:
•
Do not place the Baby Unit within reach of a child
or baby! If there is interference with the picture or
sound, try moving the units to different locations,
and ensure that they are not close to any other
electrical equipment.
•
If you place the Parent Unit and Baby Unit too close
together, you may hear a high pitched noise. This is
not a fault. The units are designed to be operated
at some distance apart. So move the units further
apart.
•
It is recommended to use a Class 10 SD Card.
(Insert the SD card with the labels facing towards
you)
Page | 22
3.2 Power On or Off the Baby Unit
•
Slide the ON/OFF switch to the ON position to
switch on the Baby Unit. The power indicator lights
up in blue.
•
Slide the ON/OFF switch to the OFF position to
switch off the Baby Unit. The power indicator goes
off if the battery is not being charged, or lights up
in red if it is charging.
3.3 Power On or Off the Parent Unit
•
To turn on the parent unit, slide the ON/OFF switch
to the ON position to switch on the Parent Unit. The
power indicator lights up in green. If the battery
is being charged, the red indicator will light up
concurrently.
•
To turn on the parent unit, slide the ON/OFF switch
to the OFF position to switch off the Parent Unit.
The green indicator goes off. If the battery is being
charged, the red indicator will continue to light up.
Using the Baby Monitor
- Quick Links:
- Time Settings
Hide quick links:
Advertisement
Table of Contents
