Maneuvering Of The Spc Booms (Presidio) - Hardi EAGLE SPB BOOM Operator's Manual

Maneuvering of the SPC booms (PRESIDIO)

To unfold the boom, do the following:
1. Check that the rear transport lock is in the storage position.
2. Press the boom lift button (H) to lift the boom clear of the transport
brackets.
3. Press and hold (B) and (D) to lower individual tilt rams.
4. Press and hold top of switch (3) to unfold the boom.
5. Press and hold the boom down button (I) to lower the boom to
correct height above crop or ground level.
To fold the boom, do the following:
1. Press the boom lift button (H) to lift the boom to highest possible
position.
2. Press and hold bottom of switch (3) to fold the boom.
3. Press buttons (A) and (C) to raise the individual tilt rams until the
transport brackets touch the vertical slide pads.
4. Press the boom down button (I) to lower the boom until it rests on
the rollers and the transport brackets are securely captured by the
transport hooks.
€
DANGER! Be careful to avoid electrical lines when folding/unfolding boom.
±
WARNING! The rear transport lock must be in storage position before folding/unfolding the boom. Failure to do so
will cause damage to the boom.
±
WARNING! Ensure that the boom is clear from the transport brackets before unfolding.
±
WARNING! The folding functions (switch 3) must only be operated when the sprayer is stationary! Failure to do so will
damage the boom.
÷
Note: Individual boom wing fold is not possible using the Presidio HZ Hydraulic system.
5 - Operation
2
3
1
5 6 7
A
B
E
I
4
8 9
H
C
D
F
G
5.13