Windsor Chariot 2 iGloss 20 Operating Instructions Manual page 37

To Replace Vacuum Filter
1. Open dust bag cover.
2. Remove dust bag.
3. Unlock bottom of filter frame by bending it slightly
and slide from under the bolt head.
4. Lift filter out of housing.
5. Reverse steps to install.
Vacuum Motor Carbon Brush Replacement
FOR SAFETY: before leaving or servicing machine,
stop on a level surface, turn off machine and
disconnect power.
Vacuum Motor Carbon Brushes
Carbon
Brushes
If armature commutator is grooved, extremely pitted or not
concentric, the motor will need to be replaced or sent to a
qualified service center.
Inportant:
These brushes wear quicker as the length shortens due to
increased heat. Spring inside brush housing will damage
motor if brushes are allowed to wear away completely.
Periodically check the length of the carbon brushes. Replace
both carbon brushes when either is less tan 3/8" (9.5mm)
long.
End Cap
3
[9.5mm]
8
86398800 Operator Manual - Chariot 2 iGloss 20
To Repair or Replace Vacuum Motor
1. Remove four (4) screws from top of control panel.
2. Tip control panel back from console to expose
vacuum motor wires.
3. Disconnect electrical connector from the vacuum
motor.
4. Replace control panel, attach with one (1) screw to
secure in place.
5. Open console.
6. Remove three (3) screws and mounting bracket
that secure vacuum motor.
7. Reverse steps to install.
MOUNT .80" FROM SEALING SURFACE OF
CONSOLE TO THE TOP OF THE MOUNTING
TABS (3).
VACUUM
MOUNTING TAB
NOTE: If vacuum motor is not mounted as shown,
vacuum may not seal properly, resulting in poor
performance.
Maintenance
.80"
CONSOLE SEALING
SURFACE
37