Windsor Chariot 2 iGloss 20 Operating Instructions Manual page 17

8. BATTERY DISCHARGE INDICATOR
Indicates the charge level of the batteries.
The indicator will be illuminated if the batteries have a sufficient charge. A slow, continuous flash indicates the
batteries require charging.
The Battery Lockout function will activate when the batteries are low.
Once active, the LED status indicator will begin to flash slowly and the controller will inhibit the burnisher motor.
The vacuum and drive remain functional. Return the unit to the charging station and charge the batteries.
NOTES: Continuing usage may damage the batteries.
When the machine is left overnight with less than a full charge, the display may initially indicate a full charge. It
will also indicate a full charge if the batteries are disconnected, then reconnected. After a few minutes of
operation the indicator will give the correct charge level.
9. HOUR METER
Records the number of hours the machine has been in burnishing operation. This information is useful in deter-
mining when to service the machine.
10. OPERATOR PRESENCE SWITCH
Must be pressed down prior to any machine functions enabled.
11. BAG PRESENT INDICATOR
Notifies operator if dust collection bag is missing. LED is red when bag is missing or not properly installed.
12. CHECK PAD INDICATOR
Notifies operator of potential problem with pad or missing pad. When LED is red, operator should remove pad
driver and verify pad condition and proper installation.
86398800 Operator Manual - Chariot 2 iGloss 20
Operation
17