Sony Digital betacam DVW-707 Operation Manual page 108

3
Set the F-RUN/SET/R-RUN switch to SET.
4
If you are using the DVW-707/709WS/790WS, set the DF/NDF
switch. (NTSC only)
DF: Drop frame mode
NDF: Non-drop frame mode
5
Using the SHIFT and ADVANCE buttons, set the time code.
SHIFT: Selects a digit to set. Each time you press it, the flashing
4
column moves to the right one digit.
Pressing this button while holding down the HOLD button
moves the flashing digit one to the left.
ADVANCE: Increments the flashing digit.
Pressing this button while holding down the HOLD button
decrements the flashing digit.
6
Set the F-RUN/SET/R-RUN switch to F-RUN or R-RUN.
F-RUN: Free run - The time code advances constantly.
R-RUN: Record run - The time code stops except during recording.
Notes
• The time code continues to advance when Loop Rec mode is
turned on, even when the system is set to REC-RUN mode.
• When you turn on the Loop Rec function, make sure either the
mode is set to F-RUN or R-RUN after setting the time code. If
you begin recording with the switch in SET position, the time code
will not be recorded correctly.
The Loop Rec function is provided by the optional BKDW-703 extension
board. For more details, see Section 3-2-3 "Starting a Shot with a Few
Seconds of Pre-Stored Picture Data (Loop Rec Function)(When Using a
BKDW-703 Extension Board) "(page 3-12)
4-30
Chapter 4 Adjustments and Settings for Recording