Advertisement
T4360G, T6360D,E Line Voltage Thermostat
Sub base Installation
The thermostat can be mounted horizontally or vertically on
the wall or a wall plate/box. Refer to Figs 2 and 3.
1.
Position and level the sub base (for appearance only).
The thermostat will function properly even when not
level.
2.
Use a pencil to mark the mounting holes.
3.
Remove the sub base from the wall and drill two in the
wall as marked. Gently tap anchors into the drilled
holes until flush with the wall.
4.
Position the sub base over the holes, pulling wires
through the wiring opening.
5.
Loosely insert the mounting screws into the holes.
6.
Tighten mounting screws.
Fig 2: Vertical Installation diagram
Fig 3: Horizontal Installation diagram
AU4360-00
Wiring
All wiring must comply with local electrical codes and
ordinances. Refer to Figs. 4 - 8 for typical wiring. A number
code is located near each terminal for identification.
CAUTION
Disconnect power before wiring to prevent electrical
shock or equipment damage.
1. Loosen the terminal screws on the subbase and
connect the fan wires (T6360E fan models only).
2. Remove the cover from the thermostat and attach
thermostat base to subbase.
3. Loosen the terminal screws on the thermostat base
and connect the system wires (all models).
4. Replace thermostat cover.
4
Advertisement
