Front View - Watchguard Firebox T30 Hardware Manual

Front View

The front panel of the Firebox T30-W.
The front panel of the Firebox T50-W.
Fail Over
The Fail Over indicator is lit when there is a WAN failover from the primary external interface to the
backup interface. After the external interface connection fails back to the primary external interface,
the indicator is not lit.
WAP
On Firebox T30-W and T50-W models, the WAP indicator is lit when the appliance is activated as a
wireless access point or a wireless client. The color indicates the active wireless radio band.
Indicator
WAP
Network interface status indicators
On the Firebox T30, the five network interfaces are labeled 4, 3, 2, 1, 0. On the Firebox T50, the seven
network interfaces are labeled 6, 5, 4, 3, 2, 1, 0. There are two status indicators for each interface.
Indicator
1000
10/100
Status
The Status indicator is red when there is a management connection to the device. The Status
indicator is lit for 30 seconds after you connect to the device with the Fireware Web UI or the
command line interface. It is also lit when the device is polled by WatchGuard System Manager.
Hardware Guide
Indicator color
Yellow
Green
Indicator color
Yellow
Blinks (speed of blink increases as
the data flow increases)
Green
Blinks (speed of blink increases as
the data flow increases)
Hardware Specifications
Wireless Status
2.4 GHz radio band
5 GHz radio band
Interface Status
Link speed: 1000 Mbps
Data sent and received
Link speed: 10 Mbps or 100 Mbps
Data sent and received
3