Connecting The Remote Control Unit - Sony DNW-7/7P Operation Manual

5-11 Connecting the Remote
Control Unit
Connecting the RM-P9 Remote Control Unit (not supplied) enables
remote control of the principal camera functions.
Turning the POWER switch of the camcorder to ON when the RM-P9 is
connected to the REMOTE connector, automatically puts the camcorder
into remote control mode. If you disconnect the RM-P9, remote control
mode is canceled.
Notes
• Always turn the POWER switch to OFF before connecting or
disconnecting the remote control cable.
• When you turn off the camcorder power, the settings and adjustments
made with the switches and controls of the RM-P9 are canceled. The
settings and adjustments made with the setup menu are saved, but some
of them are not written in the setup card.
RM-P9
Remote
connector
Remote control cable (10 m) (about 33 ft),
supplied with RM-P9
REMOTE
REMOTE

Connecting the remote control unit

Chapter 5 Setting Up the Camcorder
5
5-43