Testing The Camera - Sony DNW-7/7P Operation Manual

4
After checking the points below, load the cassette and close the
cassette lid.
• The cassette is not write-protected.
• There is no slack in the tape.
• The leader tape is wound on the take-up reel.
Condensation
If you move the camcorder from a very cold place to a warm place, or
use it in a damp location, condensation may form on the head drum.
Then, if the camcorder is operated in this state, the tape may adhere to
the drum, and cause a failure or even permanent damage. Do the
following to prevent this from happening.
• When moving the camcorder from a cold place to a warm place, be
sure no cassette is loaded in the camcorder.
6
• Whenever you turn on the power, check that the HUMID indicator
does not appear. If it appears, wait until it disappears before loading a
cassette.
For more information, see Section 3-1-1 "Loading and Unloading a Cassette"
(page 3-1), and Section 6-3 "Operation Warnings" (page 6-12).

6-1-2 Testing the Camera

Set the switches and selectors as follows:
Zoom:
SERVO/MAN
GAIN: Set as low as possible.
6-2
Chapter 6 Maintenance
Iris: Automatic
VTR SAVE/STBY: STBY
Switch and selector settings for testing
DISPLAY: OFF
WHITE BAL: A or B
OUTPUT/DCC: BARS