Audio dubbing
Dubbing with the AUDIO/VIDEO jack
Ç
: Signal flow
Note
The picture is not output from the AUDIO/VIDEO jack. Check the recorded picture on the
LCD screen or in the viewfinder, as well as check the recorded sound by using a speaker or
headphones.
Dubbing with the built-in microphones
No connection is necessary.
Adding an audio sound on a recorded tape
(1) Insert your recorded tape into the camcorder.
(2) Set the POWER switch to VTR.
(3) On the camcorder, locate the point where the recording should begin by pressing 0 or
). Then press P to set it to playback pause mode.
(4) Press AUDIO DUB on the Remote Commander .
(5) Press P on the Remote Commander and at the same time start playing back the audio
you want to record.
(6) Press p on the Remote Commander at the point where you want to stop recording.
AUDIO/
VIDEO
A/V connecting cable
Audio equipment
LINE OUT
L
R
AUDIO L
AUDIO R
Do not connect the
video (yellow)
plug.
89