Advantech WISE-4210 Series User Manual page 50

Step 5. Go to "Configuration \ Network" to configure LAN port parameters of WISE-
4210-AP.
Step 6. Go to "Configuration \ RF Module" to configure the RF module.
 RF Operation Mode: WISE-4210 end node devices supports "Push Mode", the
communication from the end node device to AP is uplink only, no downlink.
Data Rate (bps): Lower data rate is helpful of extending communication range,

while higher data rate can reduce the communication time which allows more
data to be uploaded to AP in the same period of time.
 Baseband (kHz): If several WISE-4210-AP or sub-GHz networks are in the
same area, users can select different basebands to reduce the interference of
each network. Please be noted that each WISE-4210 end node devices in the
same network should use the same baseband as WISE-4210-AP.
WISE-4210 Series User Manual 40