Connecting a redundant power supply to 2 power supply units
To connect the power supplies, use pins L1/M1 of the left terminal block "X1" and pins L1/M1
of the right terminal block "X2". Only "L1" is monitored on each terminal block.
Since both power supply units have connectors for redundant power supply, you can
connect 2 power supplies to each of the two power supply units. This should, however, only
be necessary in extremely rare situations.
Figure 5-3
● If the power supply fails at pins L1/M1 of terminal block "X1", this is indicated by LED L1.
● If the power supply fails at pins L1/M1 of terminal block "X2", this is indicated by LED L2.
5.4.2
Connecting devices with 100 to 240 VAC power supply
5.4.2.1
100 to 240 VAC - product group X-300EEC
Table 5- 5
Device
X302-7EEC
X307-2EEC
SCALANCE X-300EEC
Compact Operating Instructions, 11/2015, A5E02630809-09
Assignment of the LED display to the pins for redundant power supply with devices with
two power supply units
100 to 240 VAC power supply overview
Device version (power supply)
1 x 100 to 240 VAC / 60 to 250 VDC
2 x 100 to 240 VAC / 60 to 250 VDC
1 x 100 to 240 VAC / 60 to 250 VDC
2 x 100 to 240 VAC / 60 to 250 VDC
Connecting
5.4 Power supply
100 ... 240 V power supply
Redundant
Single
-
●
●
-
-
●
●
-
47