Table of Contents
Advertisement
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Hard disk and RAID troubleshooting information is in the
the Cisco UCS Troubleshooting Guide. The B440 uses an LSI SAS 2108 RAID controller (the onboard
version of the LSI MegaRAID 9260).
Table 3
Table 3
Supported Hard Disk Drives (HDD)
Product ID
A03-D073GC2
A03-D146GC2
A03-D300GA2
A03-D100SSD
UCS-SSD100GI1F104
A03-D600GA2
UCS-HDD300GI2F105
UCS-HDD900GI2F106
1. This drive requires UCS capability catalog version 1.0.50.T or 2.0.1nT or later.
2. This drive requires UCS capability catalog version 1.0.54.T or 2.0.1pT or later.
Removing a Blade Server Hard Drive
To remove a hard drive from a blade server, follow these steps:
Step 1
Push the button to release the ejector, and then pull the hard drive from its slot. (See
Step 2
Place the hard drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in
another blade server.
Step 3
Install a blank faceplate (N20-BBLKD) to keep dust out of the blade server if the slot will remain empty.
OL-22475-01
shows the drives supported in this blade server.
Description
73 GB, 6Gb SAS transfer rate, 15K RPM HDD/hot plug/drive sled mounted
146 GB 6Gb SAS transfer rate, 15k RPM SFF HDD/hot plug/drive sled mounted
300 GB, 6Gb SAS transfer rate, 10K RPM HDD/hot plug/drive sled mounted
100 GB SATA SSD HDD/hot plug/drive sled mounted (no longer sold)
100 GB SATA SSD HDD/hot plug/drive sled mounted
600 GB, 6Gb SAS transfer rate, 10K RPM HDD/hot plug/drive sled mounted
300GB 6Gb SAS 15K RPM SFF HDD/hot plug/drive sled mounted
900GB 6Gb SAS 10K RPM SFF HDD/hot plug/drive sled mounted
Cisco UCS B440 High Performance Blade Server Installation and Service Note
Installing and Removing a Blade Server Hard Drive
Troubleshooting Server Hardware
1
2
chapter of
Figure
3.)
11
Advertisement
Table of Contents
