Installing And Removing A Blade Server; Installing And Removing A Blade Server Hard Drive - Cisco UCS 5108 Installation Manual

Installing and Removing Components
Before you install, operate, or service the system, see the
Note
for Cisco UCS
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
Warning
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning Only trained and qualified personnel must be allowed to install, replace, or service this equipment.
Statement 1030

Installing and Removing a Blade Server

There are two types of blade server supported, half-width and full-width. Their installation is similar but with
important differences. For details, see the Blade Server Installation and Service Note for the type of blade
server you are using. The server notes are available at the following URL:
products/ps10280/prod_installation_guides_list.html

Installing and Removing a Blade Server Hard Drive

You can remove blade server hard drives without removing the blade server from the chassis. All other
component replacement for a blade server requires removing the blade from the chassis. Unused hard drive
bays should always be covered with cover plates (N20-BBLKD) to assure proper cooling and ventilation. The
chassis is omitted from illustrations here to simplify the drawing.
To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by the
Caution
carrier edges only.
for important safety information.

Installing and Removing a Blade Server

Regulatory Compliance and Safety Information
http://www.cisco.com/en/US/
Cisco UCS 5108 Server Chassis Installation Guide
71