Cisco UCS 5100 Setup page 6

3. Create VSAN to Support FCoE for FC Uplink
The FC port defaults to VSAN 1 in Cisco UCS, but, if the upstream Fibre Channel switch is connected to a
different VSAN #, the proper VSAN configuration is required on the FC ports of the Fabric Interconnect.
Complete these steps:
1. In the Navigation pane, choose SAN.
2. Choose SAN Cloud.
3. Choose the FC Uplinks for the fabric in question (A or B).
4. Right−click VSANs in the FC Uplinks of the Fabric # where you want to create the VSAN for
Uplink.
5. In the Create VSAN wizard, enter a name for this new VSAN. In this example, it is called vsan−100.
6. Now enter the VSAN ID. Remember that this has to match to an existent VSAN ID in the fabric to
which the UCS connects. In this example, VSAN 100 is used for fabric A and VSAN 200 for fabric
B.
7. Now enter the FCoE VLAN that maps to the VSAN configured in this fabric. Remember that this
VLAN has to match to an existent VLAN in the LAN network. Click OK.