General Information; Installation Instructions - Dimplex DANVILLE Opti-myst DNV20AB Manual

Technical Information :
Model No: DNV20AB, DNV20BR, DNV20BL, DNV20CH
Heat Output
Nominal Heat Output
Minimum Heat Output
Maximum Continous Heat Output P
Auxiliary Electricity Consumption
In Standby mode
with mechanic thermostat room temperature control.

General Information

Unpack the heater carefully and retain the packaging for possible future use, in the event of moving or returning the
fire to your supplier.
The fire incorporates a flame effect, which can be used with or without heating, so that the comforting effect may be
enjoyed at any time of the year. Using the flame effect on its own only requires little electricity.
The heater is designed for use inset into a 407mm (16") or 457mm (18") wide by 559mm (22") high fireplace opening
or freestanding - see also section 'Installation Instructions'.
A 2kw fan heater is discreetly positioned in the canopy of the fire provides heating in cold weather. Switching allows
half or full heat. A distance of 1 metre (39") must be maintained between the front of the heater and any surrounding
furniture, overhanging curtains or other obstrustions.
To reduce heat loss and to prevent any chimney up draft affecting the operation of your inset fire we recommend they
the chimney flue is sealed off.
Before connecting the heater check that the supply voltage is the same as that stated on the heater.
Please note: Used in an environment where background noise is very low, it may be possible to hear a sound which is
related to the operation of the flame effect. This is normal and should not be a cause for concern.

Installation Instructions

Electrical connection.
WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the supply
voltage.Before switching on, please read the safety warnings and operating instructions.
PLEASE RETAIN THIS USER'S GUIDE FOR FUTURE REFERENCE
Only use filtered tap water in this appliance.
Always ensure that the appliance is sitting on a level surface.
If you intend not using the appliance for longer than 2 weeks, drain the water from sump and water tank and
dry the sump.
Once installed, never move this appliance or lay on its back, without draining the water from sump and water
tank.
The water tank, sump, sump lid, tank cap and air filters must be cleaned once every two weeks, particularly in
hard water areas.
The appliance should never be operated if the lamps are not working.
The lamps should be regularly inspected as described under 'Maintenance' and 'Changing lamps'.
Installation Instructions
Before installing this appliance in an existing chimnney, we recommend that;
1. You have your chimney cleaned by a competent chimney sweep.
2. You block off the chimney flue.
This procedure is important for the efficient operation of the heating unit and will also reduce heat loss up the chimney.
Installation.
Ensure that all packing items are removed (read any warning labels carefully).
Retain all packing for possible future use e.g. in the event of moving or returning the appliance to your
supplier.
To install the appliance;
1. Clean the area where the fire will be installed e.g remove ash residue from an existing fireplace.
2. Use the two adjustable supports at the rear of the appliance to ensure that the fire is level.
3. Make sure the unit is switched OFF.
4. Hold the fire by the sides of surround and gently manoeuvre into position. Plug the fire into a 13amp/240 volt outlet.
230V 240V
P 1.8 - 2.0 kW
Nom
P 1.0 - 1.1 kW
min
1.8 - 2.0 kW
max,c
0.0 0.0 kW
el 3.0 - 3.0 W
SB
9