Getting Started; Charging And Installing The Battery Pack - Sony Handycam DCR-PC10E Operating Instructions Manual

Getting started

Charging and installing
the battery pack
Before using your camcorder, you first need to
charge and install the battery pack. To charge
the battery pack, use the supplied AC power
adaptor.
This camcorder operates with the
"InfoLITHIUM" battery pack. If you use any
other battery pack to operate your camcorder, the
camcorder may not operate or the battery life
may be shortened.
"InfoLITHIUM" is a trademark of Sony
Corporation.
Charging the battery pack
(1) Connect the mains lead to the AC power
adaptor.
(2) Align the hooks of the battery pack with the
AC power adaptor. Then fit the battery pack
in the direction of the arrow.
(3) Connect the mains lead to mains. The
CHARGE lamp (orange) lights up. Charging
begins.
When the CHARGE lamp goes out, normal
charge is completed. For full charge, which
allows you to use the battery longer than usual,
leave the battery pack in place for approximately
one hour after the CHARGE lamp goes out.
Unplug the unit from the mains, then remove the
battery pack and install it into the camcorder.
You can also use the battery pack before it is
completely charged.
1
8
(1)
(2)
(3)
2
3
CHARGE