Returning To A Pre-Registered Position - Sony Handycam DCR-PC10E Operating Instructions Manual

Returning to a pre-
registered position
Using the Remote Commander, you can easily go
back to the desired point on a tape after
playback.
(1) During playback, press ZERO SET MEMORY
at the point you later want to locate. The
counter shows "0:00:00" and "ZERO SET
MEMORY" appears on the LCD screen or in
the viewfinder.
(2) Press p when you want to stop playback.
(3) Press 0 to rewind or press ) to fast-
forward the tape to the counter's zero point.
The tape stops automatically when the
counter reaches approximately zero. "ZERO
SET MEMORY" disappears and the time code
appears.
(4) Press (.
1
0 : 1 2 : 3 4 : 0 0
4 0 m i n
2
Note on the tape counter
There may be a discrepancy of several seconds
from the time code.
Notes on ZERO SET MEMORY
•When you press ZERO SET MEMORY, the
counter's zero point is memorized. Press ZERO
SET MEMORY again before step 3 to cancel the
memory .
•ZERO SET MEMORY may not function when
there is a blank portion between pictures on a
tape.
•ZERO SET MEMORY functions also in
recording standby mode.
( (
0 : 0 0 : 0 0
4 0 m i n
ZERO SET
MEMORY
(1)
(2) p
(3) 0
)
(4) (
3
4
67