Replacing/Repairing; Drive Belts - Walker D21d Operator's Manual

Maintenance Instructions

REPLACING/REPAIRING

To prevent accidental starting of the en-
gine when replacing parts or repairing the
machine, remove the key from the ignition
switch and disconnect the electrical plug
on the fuel shut-off solenoid.
IMPORTANT: ALWAYS use genuine factory re­
placement parts. Substitute parts CAN result in
product malfunction and possible injury to the op­
erator and/or others.
Hydrostatic Ground
Drive Belt
76
DANGER
Jackshaft
Drive Belt

Drive Belts

There are five (5) individual belts on GHS models
or four (4) belts on SD models:
● Jackshaft Drive Belt
● Engine PTO Drive Belt (3 Groove Power Band)
● GHS Blower Drive Belt (GHS Model Only)
● Hydrostatic Ground Drive Belt
● Engine Alternator Belt
The belts may be removed and replaced using the
procedures described on the following pages.
Engine PTO
Belt
Belt Locations
REPLACING/REPAIRING
Engine
Alternator Belt
GHS Blower Belt
(GHS Model Only)