Dickson TH6P1 Getting Started

DICKSON DICK
DICK DICK
GETTING STARTED GETTING STARTED
GETTING STARTED GETTING STARTED
7-day chart rotation
0 to 100
+32 to 100F (TH6P1/2)

QUICK START

QUICK START QUICK START QUICK START
1. 1. 1. 1. Remove the protective pen caps.
2. 2. 2. 2. Connect Sensor: TH6P1/2: Make sure the R200 replaceable sensor is connected firmly to
3. 3. 3. 3. Insert 4AA batteries and plug in AC adapter (See Figure 3). Unit will power on.
4. 4. 4. 4. The instrument will move pens to the appropriate readings.
5. 5. 5. 5. Install the chart that matches selected Dip Switch settings (See p.4).
6. 6. 6. 6. Set the appropriate time. There are two ways to adjust the chart and set the appropriate
Dickson TH6P Manual V5 052418
1.800.561.8187
SON
SON SON
o
F (TH6P3)
the recorder. TH6P3: Make sure the R250 sensor is connected firmly to the 10' extension
cable and the extension cable in plugged in firmly to the recorder.
Press the PEN PEN PEN HOME PEN HOME HOME HOME key to move the pens to the outside of the chart. The pens are
automatically raised off the chart.
Remove the old chart, place the new chart on the Chart Hub being certain that the edge
of the chart slides under the Chart Guide Clip located at the outside of the chart.
time:
a. Set the chart time manually by inserting a coin into the groove in the chart hub
and turning clockwise until the correct hour (and day if applicable) on the chart is
referenced to the timing arrow (just to the right of the pens tip on the dial). Press
Pen Pen Pen Pen Home Home to move the pens back onto the chart. Home Home
www.
T T T T H H H H 6P1 /
Remote Sensing Temperature Remote Sensing Temperature/Humidity
Remote Sensing Remote Sensing Temperature Temperature
1
information@itm.com
.com
6P1 / 6P1 / TH6 6P1 / TH6P2 / TH6 TH6 P2 / P2 / TH6P3 P2 / TH6P3 TH6P3 TH6P3
/Humidity Recorder Recorder
/Humidity /Humidity Recorder Recorder