Dickson KT6P1 Quick Start Manuals

Remote sensing temperature recorder
Hide thumbs Also See for KT6P1:

Advertisement

DICKSON
DICK
DICK
DICK
SON
SON
SON
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
7-day chart rotation
0 to 100
F
o
QUICK START
QUICK START
QUICK START
QUICK START
1. 1. 1. 1. Remove the protective pen cap.
2. 2. 2. 2. Connect Probe: Make sure the KTC probe is connected firmly to the Replaceable Sensor
and that the Replaceable Sensor is plugged in firmly to the chart recorder.
3. 3. 3. 3. Insert 4AA batteries and plug in AC adapter (See Figure 3). Unit will power on.
4. 4. 4. 4. The instrument will move pen to the appropriate readings.
5. 5. 5. 5. Install the chart that matches the Dip Switch settings (See p.4).
Press the PEN
PEN HOME
PEN
PEN
automatically raised off the chart.
Remove the old chart, place the new chart on the Chart Hub being certain that the edge
of the chart slides under the Chart Guide Clip located at the outside of the chart.
6. 6. 6. 6. Set the appropriate time. There are two ways to adjust the chart and set the appropriate
time:
a. Set the chart time manually by inserting a coin into the groove in the chart hub
and turning clockwise until the correct hour (and day if applicable) on the chart
is referenced to the timing arrow (just to the right of the pen tip on the dial).
Press Pen
Pen Home
Pen
Pen
The following feature should be used for fine adjustments only.
b. To adjust the chart time, press and hold Adjust
located on the back of the unit next to the dip switch (see Figure 3).
The green LED will blink rapidly for about five seconds, then the LED will remain
solid green. While in this state the Adjust
backward (counter clockwise) and the Adjust
forward (clockwise).
Dickson KT6P Manual V3
HOME key to move the pen to the outside of the chart. The pen is
HOME
HOME
Home to move the pen(s) back onto the chart.
Home
Home
Remote Sensing
Remote Sensing
Remote Sensing Temperature
Remote Sensing
Adjust- - - - Up
Up and Adjust
Adjust
Adjust
Up
Up
Adjust- - - - Up
Up button will move the chart
Adjust
Adjust
Up
Up
Adjust
Adjust
Adjust- - - - Down
Down button will move the chart
Down
Down
1
KT6P1 / KT6P2 / KT6P5
KT6P1 / KT6P2 / KT6P5
KT6P1 / KT6P2 / KT6P5
KT6P1 / KT6P2 / KT6P5
Temperature Recorder
Temperature
Temperature
Recorder
Recorder
Recorder
Adjust- - - - Down
Down buttons
Adjust
Adjust
Down
Down

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KT6P1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Dickson KT6P1

  • Page 1 DICK DICK DICK DICKSON KT6P1 / KT6P2 / KT6P5 KT6P1 / KT6P2 / KT6P5 KT6P1 / KT6P2 / KT6P5 KT6P1 / KT6P2 / KT6P5 Remote Sensing Remote Sensing Remote Sensing Remote Sensing Temperature Temperature Temperature Recorder Temperature Recorder Recorder Recorder...
  • Page 2: Display Symbols

    DISPLAY SYMBOLS DISPLAY SYMBOLS KT6 DISPLAY SYMBOLS DISPLAY SYMBOLS Figure 1 Figure 1 Figure 1 Figure 1 Figure 2 Figure 2 Figure 3 Figure 3 Figure 2 Figure 2 Figure 3 Figure 3 Dickson KT6P Manual V3...
  • Page 3 The SPST 24V 500mA relay contacts are normally open and will close on alarm conditions when the alarms are enabled. Relay contacts are always functional when the alarm is enabled. The relay will close only during minimum and maximum alarm conditions. Relays will not operate under battery only power conditions Dickson KT6P Manual V3...
  • Page 4: Dip Switch Setup

    0 to 250 F/C #4 Up #4 Up 0 to 250 F/C 0 to 250 F/C #4 Up #4 Up #5 Down #5 Down #5 Down #5 Down #6 Up #6 Up #6 Up #6 Up Dickson KT6P Manual V3...
  • Page 5 Each time the Pen Home or On/Off button is pressed, the adjustment currently in progress will be stored. The unit will take one minute to exit Pen Adjust Mode once the On/Off button is pressed. Dickson KT6P Manual V3...
  • Page 6: User Calibration

    Note: It is recommended that you use a controlled chamber when determining if Calibration is necessary. Adjusting the pen in an open room is not recommended as air flow can vary greatly within a very small area. Dickson KT6P Manual V3...
  • Page 7: Troubleshooting

    Why won't the battery back- - - - up work? up work? up work? up work? Are there good batteries in the Chart Recorder? • Keep in mind that battery backup varies significantly depending on temperature, • pen movement and chart rotation speed. Dickson KT6P Manual V3...
  • Page 8: Warranty

    WARRANTY WARRANTY Dickson warrants that this line of instruments will be free from defects in material and workmanship under normal use and service for a period of twelve months after delivery. This warranty does not cover routine calibration and battery replacement.
  • Page 9 Replaceable Sensor Certificate of Validation Replaceable Sensor Certificate of Validation Replaceable Sensor Certificate of Validation Dickson ensures that the Replaceable Sensors / Instruments listed below were developed, tested and validated together. Replaceable Sensor Model: R400 Instrument Model: KT6P1, KT6P2, KT6P5...

This manual is also suitable for:

Kt6p2Kt6p5

Table of Contents