Step 2: Charging The Battery Pack - Sony Handycam DCR-PC108E Operation Manual

Step 2: Charging the
battery pack
You can charge the battery by attaching the
"InfoLITHIUM" battery pack (F series) to
your camcorder.
b Notes
• You cannot use batteries other than the
"InfoLITHIUM" battery pack (F series) (p. 129).
• Do not short-circuit the DC plug of the AC Adaptor
or battery terminals with any metallic objects. This
may cause a malfunction.
• Use a nearby wall socket when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
socket immediately if any malfunction occurs.
DC IN jack
Handycam Station
Mains lead
To the wall socket
16
Getting started
1
2
DC plug
3
AC Adaptor
4
5
Slide the BATT (battery release)
lever and remove the battery terminal
cover.
BATT (battery release) lever
Attach the battery pack with its
terminal side facing your camcorder as
shown in the following illustration and
press down the battery pack until it
clicks.
With the v mark on the DC plug facing
up, connect the AC Adaptor to the DC
IN jack on the Handycam Station.
DC IN jack
Connect the mains lead to the AC
Adaptor.
Connect the mains lead to the wall
socket.
v
mark