Advertisement
Table 3-H – Power Connector
Conn #
Signal
22
MOTOR GND
23
MOTOR
PHASE R
24
MOTOR
PHASE T
25
MOTOR
PHASE S
26
-DC BUS
27
+ DC BUS
28
INT SHUNT
29
EXT SHUNT
30
AC LINE 1
31
AC LINE 2
32
AC LINE 3
33
EARTH GND
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Signal Description
Chassis ground motor side. Connected internally to the Earth ground
terminal.
Motor power phase R.
Motor power phase T.
Motor power phase S.
High power negative DC voltage.
High power positive DC voltage.
This terminal pin is linked with terminal pin #27 to enable the internal
brake resistor (default). If an external shunt is required, disconnect
this internal shunt resistor by removing the link between terminals 27
and 28. See the "Special Applications" section.
This terminal is used to drive an external brake resistor instead of
the internal one. The external brake resistor will be connected
between this terminal pin and pin#27. If an external shunt is
required, disconnect this internal shunt resistor by removing the link
between terminals 27 and 28. See Chapter 6.
Phase 1 of the AC line.
Phase 2 of the AC line.
Phase 3 of the AC line.
Chassis ground power supply side. This is not connected to the logic
side common. It is connected to the amplifier frame.
Section 3– Page 19
Advertisement
